Now in various fields of production technologies are applied, using infrared – beams. One of the lines used by car services – drying paint and preparatory materials. In the infrared – heat drying begins with surface of the product due to penetrating properties of infrared – beams. This in turn prevents the exit of the solvent from the inner layers, which will positively affect the drying time and quality of coverage. Solvent in the surface layer increases its concentration, while improving the spreading of paint on the surface of the coated product and as a consequence – to improve the quality of the coating.
Infrared heating equipment does not require additional space as well as can not apply Spray drying kilns for painting parts of the car (hood, fender, door). A distinctive feature of the IR-drying is a high performance and high quality of drying. Use IR-drying allows you to:-Reduce by 2 times cost of electricity for the drying process. -Reduce to 4 times during the process of drying. -Improve the quality of paint.
In the Russian market of IR dryers are present as domestic and foreign producers, one of these is TROMMELBERG (Germany) Mobile Infrared shortwave with three cartridges for high-performance coatings and drying training materials in the automotive industry. Features: Suitable for drying two-component and single-component materials, as well as for water-borne paints and grounds Each of the cassettes positioned individually, turning to 90 degrees. The cassette assembly can be rotated in 360 degrees. As well as raised and lowered to the desired height. The migration process is controlled by the height gas shock absorber Ultrasonic sensor allows the position of the item at the right distance from the radiator, which prevents overheating or insufficient drying of the surface. With over a short distance heaters will turn off automatically Digital display: an accurate representation of the drying time and distance indicator to the dried surface High efficiency Faster curing radiation through penetration of infrared radiation into the inner layers of material Full-drying for 15 minutes – for 2K acrylic paints, and within 5 minutes – for polyester putty Uniform heating of the dried surfaces Long life Infrared emitters – over 6,000 hours! New ergonomic control panel with 4 memories for programming of drying and drying by installing timers psevdosensorov. Manufacturer: TROMMELBERG Effectively You can use the equipment for drying putty and ground, finishing coatings, enamels, and for these operations is required from 5x to 15ti minutes. At the same time energy costs are reduced by about a factor of 2.5. IR – dryer is widely used car services, service stations and repair shops of various organizations. A distinctive feature of this equipment is a different number of tapes (from 1 to 6 pcs.) dried surface ranged from 0.6 x 0.4 m to 1.0 x 1.5 m.